1) The walking belt and/or deck are worn. (85% of the time) 2) The walking belt and/or motor belt are too tight- if you have adjusted either recently. (8% of the time) 3) The motor has lost torque and needs brushes or has demagnetized. (5% of the time) 4) The controller board is dropping output. (2% of the time) . You can do it foryourlsef. However i will give some websites FOR TO CONTACT THEM:
Answers & Comments
There are four typical causes for this problem :
1) The walking belt and/or deck are worn. (85% of the time)
2) The walking belt and/or motor belt are too tight- if you have adjusted either recently. (8% of the time)
3) The motor has lost torque and needs brushes or has demagnetized. (5% of the time)
4) The controller board is dropping output. (2% of the time) . You can do it foryourlsef. However i will give some websites FOR TO CONTACT THEM:
www.unitedassemblers.com + www.treadmildoctor.com
Sincerely. Merry Christmas.
ERNESTO CUADRA
MANAGUA, NICARAGUA.