First, assume that the white wire is the common and connect that to the C terminal. Then connect all of the other colored wires to station terminals, starting with terminal 1 until you are out of wires. Then turn on zone one manually. If it works, note where it is on your property and turn on zone 2. Do the same until you have run all of your zones. Lastly, move the wire connections on the terminals so that there is some order as to how the zones come on around the property. If no zones run when you try to run zone 1, disconnect the white wire from the C terminal and try connecting the green. Try your zones again. If none of this works, you need an electrical testing meter (multimeter) to determine which wire/wires are the common(s). Gary
Answers & Comments
First, assume that the white wire is the common and connect that to the C terminal.
Then connect all of the other colored wires to station terminals, starting with terminal 1 until you are out of wires.
Then turn on zone one manually. If it works, note where it is on your property and turn on zone 2. Do the same until you have run all of your zones.
Lastly, move the wire connections on the terminals so that there is some order as to how the zones come on around the property.
If no zones run when you try to run zone 1, disconnect the white wire from the C terminal and try connecting the green. Try your zones again.
If none of this works, you need an electrical testing meter (multimeter) to determine which wire/wires are the common(s).
Gary