1) Element has gone bad... this is unusual. 2) Temp Sensor has failed, this is more commen (had it happen to mine.. differnet model though)
3) main board that temp sensor reports to is bad...
You can usually test the sensor with a DDM (Digital Volt Meter) as they are usually just a switch that is on/off.
This is a link to the parts manual. On page is it shows item 5 which is a temp sensor. It appear to have a manual resset, which might start you going again. Unfortuanatly I am not eactly sure where it is located... looks like on the bottom of the righ side somewhere... might be behind a panel....
That said, if it is the problem, it tripped for a reason (or maybe it is just going bad). Check your exhaust duct and outlet to make sure it is not clogging up and becoming a hazard.
Answers & Comments
Couple of possibilities.
1) Element has gone bad... this is unusual.
2) Temp Sensor has failed, this is more commen (had it happen to mine.. differnet model though)
3) main board that temp sensor reports to is bad...
You can usually test the sensor with a DDM (Digital Volt Meter) as they are usually just a switch that is on/off.
This is a link to the parts manual. On page is it shows item 5 which is a temp sensor. It appear to have a manual resset, which might start you going again. Unfortuanatly I am not eactly sure where it is located... looks like on the bottom of the righ side somewhere... might be behind a panel....
That said, if it is the problem, it tripped for a reason (or maybe it is just going bad). Check your exhaust duct and outlet to make sure it is not clogging up and becoming a hazard.
Peace,