Xerox Workcentre PE220 doesn't load paper. Stopped loading paper, and I found a torn rubber ring inside. I found where it was, but can't figure how to replace it
Office Equipment & Supplies - Xerox - WorkCentre 220 All-In-One Laser Printer
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
No need replacement. Take a sandpaper and clean the roller. Well, all done.
It sounds like you need to replace your paper pick roller. It is held on the shaft by some white plastic clips. You can pry the tabs up and slide them to the side, then rotate and drop out the pick roller assembly. You'll need to find a source for that part.
You need to follow on your edocs.find a part number for your pick up rollers.