Yes i have a 00 model nissian quest van. 3.3 v-6 motor i cant find nobody who knows what the mains and rods torque at. i put a new crankshaft in the van and dont know what to torque the rods and mains at. thank you
Main bearing cap bolts: tighten them in three steps, in sequence, to 67-74 ft. lbs. (90-100 Nm).
rods: Lubricate the threads with new engine oil and install the nuts, using the following procedure:
Tighten the nuts to 10-12 ft. lbs. (14-16 Nm).
Using a torque angle meter, tighten the nuts an additional 60-65°. If a torque angle meter is not available, tighten the nuts to 28-33 ft. lbs. (38-44 Nm).
Answers & Comments
Main bearing cap bolts: tighten them in three steps, in sequence, to 67-74 ft. lbs. (90-100 Nm).
- Tighten the nuts to 10-12 ft. lbs. (14-16 Nm).
- Using a torque angle meter, tighten the nuts an additional 60-65°. If a torque angle meter is not available, tighten the nuts to 28-33 ft. lbs. (38-44 Nm).
rods: Lubricate the threads with new engine oil and install the nuts, using the following procedure: