Zebra 2824 red light
Hi there, sorry to bother you, I noticed a posting for zebra 2824 going red after printing a few labels, press green then print a few more and goes red, i tried manaul calibration, checked label size being spot on but it still goes red, any other reasons, would be much appreciated
tx
darren ([email protected])
tx
darren ([email protected])
Office Equipment & Supplies - Zebra - TLP 2844-Z Thermal Label Printer
Answers & Comments
1: your ribbon is not set correctly on it's possition ( it has one hole to hold by role) u have to check it first or your ribbon is set badly
2 : it's door sensor is error base , if u press on door and send a print red light prob was solved ur door sensor should be cleaned , ...
I have this exact same problem. Any help or suggestions greatly appreciated.
Hold the feed button while turning on the printer. After a config label prints, turn the printer off and then on again, and try printing again.
Also, make sure the lid is closed far enough to engage the lid sensor. If the red light comes on again, press down a bit on the lid, hit the feed button and try to print again.