California 1100 EV Touring - Tips for writing user manuals

California 1100 EV Touring Owners Manuals, User Guides, Instructional Help Documents & Information.

Featured Questions

Preliminary list of posts to be most interested community
hard to pull in - 2002 Moto Guzzi California 1100 EV Touring
Answer
I have a 2003 Calif. EV. I left the bike for 2 weeks and found the battery was completely dead. I replaced it and when I turned it on the fuel pump made a different sound. The bike started and I drove it home from the storage unit. I left it sit for about 1 hour and then went to start it up again it turned over but did not start. I think the fuel pump was not operating when I turned on the ignition. Also, when I was driving back to my home (approx. 2 miles), the tachometer was jumping around
Answer
1100i sport misfire myecu fitted ,new tps, fitted new phase sensor fitted, injectors cleaned, new relays injector throtel body sync,t conections cleaned and lubed with silicone grease , valve clearance increased it now ticks over but some time cuts out. At 2000 to 3000rpm shunts the transmison and mises up the rev range and is still noticeable at high speed, still the same problem with the original setup any sugestions ! dave
Answer

Latest Questions

Latest posts in community
I have a 2003 Calif. EV. I left the bike for 2 weeks and found the battery was completely dead. I replaced it and when I turned it on the fuel pump made a different sound. The bike started and I drove it home from the storage unit. I left it sit for about 1 hour and then went to start it up again it turned over but did not start. I think the fuel pump was not operating when I turned on the ignition. Also, when I was driving back to my home (approx. 2 miles), the tachometer was jumping around
Answer
hard to pull in - 2002 Moto Guzzi California 1100 EV Touring
Answer
1100i sport misfire myecu fitted ,new tps, fitted new phase sensor fitted, injectors cleaned, new relays injector throtel body sync,t conections cleaned and lubed with silicone grease , valve clearance increased it now ticks over but some time cuts out. At 2000 to 3000rpm shunts the transmison and mises up the rev range and is still noticeable at high speed, still the same problem with the original setup any sugestions ! dave
Answer

Helpful Links

Helpful Social

Copyright © 2024 QA.XPDF.PUB - All rights reserved.