InSinkErator Badger 5, 1/2 HP Garbage Disposal - New Manuals & User Guides

InSinkErator Badger 5, 1/2 HP Garbage Disposal Owners Manuals, User Guides, Instructional Help Documents & Information.

Featured Questions

Preliminary list of posts to be most interested community
2 HP Garbage Disposal
Answer
2 HP Garbage Disposal
Answer
Badger 5 leaking out bottom where the electrical cord is
Answer
2 HP Garbage Disposal
Answer
2 HP Garbage Disposal
Answer
can be replaced?
Answer
2 HP Garbage Disposal
Answer
2 hp disposal that, when it fills with water, leaks under the sink
Answer
Badger 5 spins freely with wrench, but not with power
Answer
It is leaking from the bottom where the electrical cord goes into the unit
Answer
My garbage disposal runs but turns VERY slowly, nothing is stuck, it just turns slow and steady
Answer
The garbage disposal turns on, but the blades are not rotating. It sounds like the motor is not turning over
Answer

Latest Questions

Latest posts in community
I would like to know where the plug for the dishwasher drain in my new badger 1 disposal is?
Answer
Insinkerator badger 5 runs sink wont drain
Answer
It is leaking from the bottom where the electrical cord goes into the unit
Answer
2 HP Garbage Disposal
Answer
The garbage disposal turns on, but the blades are not rotating. It sounds like the motor is not turning over
Answer
can be replaced?
Answer
My garbage disposal runs but turns VERY slowly, nothing is stuck, it just turns slow and steady
Answer
Badger 5 leaking out bottom where the electrical cord is
Answer
My Badger 5 is leaking from a hole in the side, close to the top of the disposal. It looks like a weld might have broken and punched a small hole in the side. Is this possible? I did have to pull a foriegn object out of it that we had gone down and chewed up after the dishes were done. Thanks!
Answer
Badger 5 spins freely with wrench, but not with power
Answer
2 hp disposal that, when it fills with water, leaks under the sink
Answer
The disposal makes a terrible noise like it has glass in it when I turn it on. The table and blades move freely, food is chopped and washed away properly. One of the "screws" attaching the blades appears to be looser than the other. It kind of wiggles when I put my hand down there whereas the screw attaching the other blade does not move at all. I've run food down it and it seems to be working properly. I've pushed the reset button, and I've tried to tighten the one screw with my fingers. It still sounds loud when I turn it on
Answer
Sink only drains when garbage disposal is run. Have cleaned trap, snaked pipe and no clogs still wont drain unless disposaln is tturned on
Answer
What will happen if a coin falls into a garbage disposal
Answer
Insinkerator hums when turned on, but does not start. Blades turn freely when hex key is used on the bottom
Answer
Disposal was jammed. I unjammed it and it worked fine for just a few times. The blades now turn freely, but now it trips the circuit breaker the instance I turn it on
Answer
My InSinkErator Pro 333 is leaking at the bottom. It has served faithfully for a long time. If this model is no longer available, what is its current equivalent ?
Answer
2 HP Garbage Disposal
Answer
Troubleshoot garbage disposal Badger Model 5-81
Answer
Insinkerator 60s; no jambs I can see, but very loud and vibrates
Answer
Leaking from the metal plate where the water hose is
Answer
Reset button leaks every time I use the disposal
Answer
Could not locate reset button. do all models have a reset button?
Answer
HOW DO I REMOVE THE BLADES? I THINK SOMETHING IS
Answer

Helpful Links

Helpful Social

Copyright © 2024 QA.XPDF.PUB - All rights reserved.